rockspace wifi extender red light Archives • Re.Rockspace.local

Lights mean on Rockspace repeater

Austin Parker — Thu, 15 Oct 2020 15:03:32 +0000

In this article, we will teach you what do the Lights mean on Rockspace repeater? We will provide you with a full description of this.

Rockspace local wi-fi extender refers to a repeater to boost the signal and prevent it from dead zone areas. However, re. rockspace local wi-fi extender works at 2.4G band thereby giving full signal coverage with a transmission speed of 300 Mbps.

RST Button– You can use the end of a paper clip or the same object to press down and hold up this button around about 8 seconds with power on, and then release it to restore the extender to factory resetting.

Lights mean on Rockspace repeater

1. Power LED

Solid On – It means the repeater has started
Blinking- It refers to the repeater is starting
Off – Off refers to the repeater is not powered on.

2. WPS LED

On – It will show a WPS connection. It has established.
After that, Blinking– A WPS connection is being established
Off– It means the WPS function is disabled

3. Moreover, Signal LED

Solid Blue- The repeater has connected to your existing Wi-Fi router/modem, and its position is proper.
Solid Red- It means the repeater is too far away from the router to relocate the repeater nearer to the router.
Off– Off represent the repeater does not connect to your Wi-Fi router.

The post Lights mean on Rockspace repeater appeared first on Re.Rockspace.local.

What do the lights mean on Rockspace Repeater?

Austin Parker — Thu, 15 Oct 2020 07:01:25 +0000

Confused about the LED behavior on your Repeater? When indicator shows red or no light what that means, either weak signal or fled connecting? How to confirm a successful extension? We know you all have this type of question with you. Don’t worry we will help you out. Must read the full article carefully it will resolve What do the lights mean on Rockspace Repeater.

lights mean on Rockspace Repeater

LED status on Repeater

1. Firstly you need to search the signal to check if there is a repeater factory SSID.
Note: In case the SSID of the signal is still the factory setting, then that means it is a failed extension.
2. Now you can observe the exact same color and status of the LED indicator by darkening the surround. (You need to look into a dark place like a room)
3. After that log in to the interface of the repeater to check if the extended state is extended.
4. Here if you are fully sure that the extension is successful, then only you can position the antenna in an upward direction and parallel to each other with the antenna of the router.
Note: In case not, then please reposition its angle.
5. Finally now you can place the repeater and router near each other and observe if the LED indicator turns to solid blue.
Here this is finally done.

We hope this article helped you to solve your issue.

The post What do the lights mean on Rockspace Repeater? appeared first on Re.Rockspace.local.